Kone MX32 with KCM831

greenspun.com : LUSENET : Elevator Problem Discussion : One Thread

The harness coming off of the machine has a 10 wire plug-in...the problem is there is'nt any where to plug in on Lce board...Is this a factory mistake?....What is the switch on the side of the motor at the bearing location for? scary!...I wish Kone Had a little more info on their products to hand out to their Mechanics..

-- Brian Kohlhaas (bkohlhaas@aol.com), September 10, 2003


Brian, there is A LOT of information available from Moline. Ask your supervisor to order it for you.

-- JL (jean.laroche@kone.com), September 10, 2003.

Moderation questions? read the FAQ