ADJ. CHAIN : LUSENET : MV Agusta F4 : One Thread


-- howard miller (, July 08, 2002


Easy! Just use your 10mm bit that is included in your tool bag under the seat. Use it to loosen the two 10mm sqrews at the top of the excentric hub. I normaly carry a 10mm open end wrench with my tool kit. You can use it for leverage. Then just rotate the hub until the chain is properly adjusted. The adjusting measurements are listed on the lower chain guard. Kevin, Orlando,Fl.

-- kevin warner (, July 08, 2002.

be carefull when adjusting the chain. rotate the excentric device in the good direction. excissive mis-adjusting may cause the rear tyre to hit the exhaust pipes on bad roads success !

-- kris hoffelinck (, July 13, 2002.

Moderation questions? read the FAQ