"45" motion fault

greenspun.com : LUSENET : Elevator Problem Discussion : One Thread

i have a miprom 21 getting an intermittent "45" fault on the motion log, but there is no documentation on it.44 is as high as it goes....any ideas? i have suspicions and i will post any conclusions....was just wondering if anyone had run across this yet

-- bruno (bustrk66@aol.com), August 29, 2001


it is bad encoder dir.

-- jag (gipper067@yahoo.com), September 05, 2001.


if it gets worse make sure your 12v or 5v supply is stable and the grounding is ok, next change the encoder, next the msu or rpb

-- cliff smith (cliff77@at.net), October 27, 2001.

Moderation questions? read the FAQ